Abstract
Microplastic contamination in freshwater ecosystems poses a critical environmental challenge, necessitating effective removal technologies in wastewater treatment. This research aims to evaluate the efficiency of a hybrid removal system for polyethylene microplastics (particle sizes 0.15–1 mm) by integrating chemical coagulation with simple sand filtration. The performance of three coagulants—alum, polyaluminium chloride (PAC), and ferric chloride—supplemented with chitosan as a coagulant aid, was optimized across various dosages and pH levels, followed by the evaluation of a sand filter column under different flow rates. The results indicated that coagulation efficacy was pH-dependent, peaking at pH 7, where PAC achieved the highest removal efficiency of 77.41 ± 4.47% for fine 0.15 mm particles, followed by alum (73.22 ± 3.54%) and ferric chloride (63.18 ± 3.63%); notably, the combined system operating at a flow rate of 15 mL/min (Experimental Set 1) attained an exceptional overall removal efficiency of 99.93%. These findings demonstrate that coupling chemical coagulation with low-cost sand filtration offers a robust and scalable solution for significantly reducing microplastic discharge in synthetic wastewater applications.
Acknowledgements
The authors acknowledge the financial support from Mahasarakham University, Maha Sarakham 44150, Thailand.
Funding
The authors received fund from Mahasarakham University, Maha Sarakham 44150, Thailand.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Competing interests
The authors declare no competing interests.
Ethical approval
This research was approved by Human Research Ethics Committee of Mahasarakham University, certificate number 378–381/2024, 26 June 2024.
Additional information
Publisher’s note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Supplementary Information
Below is the link to the electronic supplementary material.
Supplementary Material 1 (download PDF )
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article’s Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article’s Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
Reprints and permissions
About this article
Cite this article
Poolborwornrak, P., Khiewkhern, S., Wibuloutai, J. et al. Efficiency of a microplastic removal system from synthetic wastewater using a chemical process combined with simple filtration.
Sci Rep (2026). https://doi.org/10.1038/s41598-026-59084-8
Received:
Accepted:
Published:
DOI: https://doi.org/10.1038/s41598-026-59084-8
Keywords
- Efficiency
- Microplastics
- Synthetic wastewater
- Chemical process
- Filtration
Source: Resources - nature.com
